[Amps] RE: 4CX250B Screen Supplies
Bill Fuqua
wlfuqu00 at uky.edu
Thu Jul 29 15:49:11 EDT 2004
Not so hard, simply pick off a small bit of signal and put it into a
balanced mixer with associated crystal oscillator (14.318MHz easily found)
and lowpass output and put into your sound card. Use FFT program and you
have a cheap spectrum analyzer with high resolution. Do not use your
receiver unless you are sure you can eliminate RF pickup from within the
shack. RF passing thru rectifying diodes to the power line will produce 120
and 60 Hz amplitude modulation on the signal.
73
Bill wa4lav
At 09:40 AM 7/29/2004 +0100, peter.chadwick at Zarlink.Com wrote:
>Rich said:
>
>
> >With 30Hz or so tone spacing, it's going to
> >take an incredibly capable spectrum analyzer to separate and measure
> >the 3rd and 5th order products.
More information about the Amps
mailing list