[Amps] Tube Burn In Question.
R.Measures
r at somis.org
Fri Jun 18 23:00:53 EDT 2004
On Jun 18, 2004, at 7:17 PM, ab5mm wrote:
> The 20+ year old 3-500Z Eimacs have lost their brilliance.
=F0 See an ophthalmologist ASAP..
> I finally broke down and purchased a new pair to go into the Henry=20
> 3K-A today at HAM-COMM.
> My question is how should I "burn in" the tubes?
=F0 I never have. So far, no problem. The Amperex and the Eimac =
3-500Z=20
tech data sheets say nothing about burn-in.
- If you hear any arcing, it's not from inside the vacuum, so don't=20
expect it to get better from self-gettering.
good luck, Steve
> How many hours?
> Only filament and blower on? (I did the mod to cool the pins)
> Filament voltage? (I can vary it)
> And finally, is there a general consensus on whether or not some=20
> portion of the burn in time should include plate voltage (no drive,=20
> just idle current? (I can vary this also)
>
> As always, Thank You for the input.
>
> Steve
> AB5MM
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
More information about the Amps
mailing list