[Amps] FS: Test EQ. & Attenuators
Radio WC6W
wc6w at juno.com
Sat Nov 20 15:40:15 EST 2004
*** Test Equipment -- all functional!! ***
EH Research G710 50 Mhz Single/Double Pulse generator 20Hz-50MHz in ten
ranges, 10nS-50mS delay, 10nS-50mS width, amplitude control for
complementry outputs, plus internal/external trigger in, trigger out.
8+" wide x 3+" hi x 12" deep. $150
EH Research G750 100 Mhz Single/Double Pulse /Sq. Wave generator
6Hz-100MHz in twelve ranges, 10nS-50mS delay, 10nS-50mS width, amplitude
control for complementry outputs, offset control, plus internal/external
trigger in with level control, trigger out. 8+" wide x 3+" hi x 12" deep.
Note: Square wave mode only above 50 MHz. $200
General Radio 758-A 55-400 MHz Wavemeter. Dial in need of severe
polishing; Insides are clean. $20
Heathkit IM-4180 FM Deviation meter. Early 80's vintage. $100
Hewlett Packard 141T Spectrum Analyzer system including mainframe, 8552B
IF section, 8553B, and 8555A RF sections plus 8443A Tracking generator.
All original knobs, terminators,etc. clean and working fine.
With manuals (or copies thereof...) for all units. $2200
Hewlett Packard 427A (transistorized) volt-ohmmeter with nice 4" mirrored
scale. Reads as low as 10 mV full scale on AC and up to 1000V AC or DC.
A spare battery and an original HP manual are included -- $75
Hewlett Packard Strobline Demonstrator. A rare sales tool from the late
1960's for dot matrix readouts built in a 5"x3"x11" deep series 1 HP
cabinet. Complete your HP collection now! Working! $100
Harrison (later HP) 865B 40V .5A Max. Constant Voltage-Constant Current
Laboratory Power Supply -- $25
LM13 series Frequency meter - Bendix CRR-74028 with homebrew power supply
attached. An SO-259 has been installed in lieu of the stock RF
connector. Original calibration manual included. $10 or... free (plus
20lbs worth of shipping!) with $50 purchase of other stuff on the list.
McMurdo Silver model 903 Wavemeter coils: #100, 102, 103, 104 ,105 & 106
in original boxes. I also have the empty box from coil #101 and the
instruction sheet for the Wavemeter.... and no, I do NOT have the meter
itself. $20 all
Kepco Dual PCX 15-1.5 MAT 15 volt 1.5 amp max lab power supply in Kepco
PC-4 cabinet. Individual voltage & current meters (4 total). Ten turn
voltage adjusts -- $50
Olson model CB-067 SWR & Field Strength meter. In half of original box
with instructions & short UHF-UHF cable. Screw in whip antenna is
missing. Rated 1KW. UHF connectors. Little used, late 1970's vintage.
$15
Tektronix DD501 Digital Delay module for TM500 series mainframe. 1-99999
counts up to 65 MHz. $150
Tektronix PS502 Triple Power Supply for TM500 series mainframe. 5V @ 1A
plus, dual adjustable tracking 10-20 volt @ 400mA. $125
Tektronix SW503 1-400 MHz Sweep Generator for TM500 series mainframe
w/manual. $600
TEI model 28-200 relative power / SWR / Field strength meter -- screw in
whip antenna is missing. UHF connectors. $7
*** RF Attenuators ***
Heavily built RF Attenuator, adjustable between 0-50dB in 10dB steps.
8" flying leads w/one terminated in a BNC Bulkhead female and the other
with an N Male connector. Looks like it should be good to at least 1
GHz. 3 1/2"
diameter by 4" deep overall and weighs about 4 pounds. Tapped holes in
the front frame for panel mounting. No manufacturer indicated. A 3/8"
shaft adjusts by pulling (with a spring return) and turning so there is
no chance of inadvertent resetting. No knob nor dial is included. $25
Adjustable RF Attenuator 0-10 dB -- Telonic TB-50A. 0-10dB (1dB steps)
50
ohm RF attenuator-- 3" diameter by 3" deep w/ side mounted BNC
connectors. $15
6 dB low power pads with N connectors, male on one end, female on the
other. Approx. 1"x1"x3" overall. 2 left. $10 ea.
*** Homebrew Radio things ***
Many hams build things with a large investment in time & parts that are
worth far less... later. Here are some items from the estate stuff I've
been selling that fit that description -- priced accordingly.
Unless noted, most of the items below are built on PCB material and most
of the enclosures are made by soldering pieces of PCB material into a box
-- not all sides may be present! Batteries not included! A few of
these devices come with schematics, mostly not. The wiring is all open
enough that you can generally see what is going on.
PL Tone generator -- Wein Bridge Oscillator powered by two 9 volt
batteries (not included). - $1
Touch Tone Encoder -- Western Electric Touch Tone Dial mounted in a
4"x4"x2" metal enclosure with power switch. Has a 4 pin DIN connector
plus matching cable terminated in a 1/8" mini plug. $2
Some kind of test oscillator with a NE556, two pots with anodized gold
(colored) knobs, pwr. sw.. LED,. & Banana jack outputs -- $3
PPG Electronics project #880-CB, 13.5V 2 Amp, power supply kit, unbuilt.
Most parts are under shrink wrap. Power transformer & main filter cap
are missing. $4
HF Harmonic Filter built in a 5" x 2.25" x 2.25" LMB Aluminum box. UHF
connectors. Probably good for 100W. $5
435 MHz power splitter with (3) N connectors. This is made out of brass
sheet stock and is about 15" long by 1" square. $10
Some kind of VHF thing just started. Pomona 4"x2.5"x1.5" cast box with a
couple 160-104 capacitors, BNC connectors, a miniature 50K bourns pot., 6
capacitors mounted to gold plated terminals with a very pretty gold
flashed internal shield structure. Nothing is soldered -- this was just
started. $10
Two Meter to 24-28 MHz receiving converter (I think!) -- 5" x 4" x 1.75"
-- $10
Transistor Tester per July 76 Ham Radio, p.40. Homebrew Aluminum case.
NPN/PNP select switch is broken but, a replacement is included along with
a copy of the article. Nice sealed Weston 50uA meter.-- $12
All of the above plus shipping, if necessary, naturally.
Contact: Marv WC6W 310 649 3111 (reasonable hours Pacific Time
please)
or via wc6w at juno.com
*
________________________________________________________________
Juno Platinum $9.95. Juno SpeedBand $14.95.
Sign up for Juno Today at http://www.juno.com!
Look for special offers at Best Buy stores.
More information about the Amps
mailing list