[Amps] Transformer shop

[Will Matney]

I figured I'd better give this update about the transformer shop 
starting. I was shooting at December to start back working and doing the 
transformers but something has came up again. Most know, I've had two 
knee surgeries this year to keep my kneecaps from freezing. Both times 
they kept me from doing much for a while. Now, they have me scheduled to 
see a plastic surgeon next month, to see if they can straighten them 
again. If so, this may delay things from happening again, I'm not sure. 
They may either want to do the surgery then, or wait until next year (I 
hope). If they wait until next year, I'll go ahead and start it up. If 
not, it may be after January-February until I can, I'm not sure. Seems 
like every time you get a toe-hold and get ahead, something comes up to 
slow it down.

Anyhow, I do have everything here now to start it. I'm building the 
winder up now, and have some other needed test equipment for measuring 
inductors, etc. I've not purchased any iron or wire yet and am waiting 
to do that as it is expensive to do. That was to be done next month 
starting out, but from above, it may not happen. I'll let everyone know 
who was interested.

One last thing. If a doctor wants to run a full EMG on you, run like 
h#ll. That was about the most miserable I've been over a test!

Best & 73's

Will Matney