Fw: [Amps] AIR-DUX coil info wanted

[Will Matney]

----- Original Message -----
From: "Will Matney" <craxd1 at ezwv.com>
To: "Henry Turner" <hturn at sbcglobal.net>
Sent: Sunday, October 24, 2004 11:17 PM
Subject: Re: [Amps] AIR-DUX coil info wanted


> Henry,
>
> I'm not sure on this, or if it might be there, but did you take a look at
> the Barker & Williamson website? Most all air-coil manufacturers (similar
> products) were made with the same spacing, I.D. and lengths. This way one
> manufacturers coils would fit in anothers place. There is some standard
> charts in the ARRL handbook as a matter of fact. B&W owns the Miniductor
and
> Airdux trademarks so most likely it will show up.
>
> B&W Website:  http://www.bwantennas.com/
>
> Best & 73's
>
> Will Matney
>
>
>
> ----- Original Message -----
> From: "Henry Turner" <hturn at sbcglobal.net>
> To: <amps at contesting.com>
> Sent: Sunday, October 24, 2004 9:37 PM
> Subject: [Amps] AIR-DUX coil info wanted
>
>
> >
> > I am in need of the dimensions of Air-Dux Coil
> > # 195-2.  What size wire, spacing, diameter, etc.
> > are needed.  Anyone have an old spec sheet?
> >
> > Thanks
> > Henry
> > K5YDD
> >
> > _______________________________________________
> > Amps mailing list
> > Amps at contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >
> > __________ NOD32 1.880 (20040928) Information __________
> >
> > This message was checked by NOD32 antivirus system.
> > http://www.nod32.com
> >
> >
>