[Amps] Removing enamel insulation?

[DaleLeStourgeon]

There was an article a while back in Electric Radio that recommended 
using an asprin, solder, and soldering iron all together. Supposedly 
takes off the enamel and tins at the same time.
73
Dale K5AJZ

Joe Subich wrote:

>Does anyone have a good way to remove enamel (Formvar?) from thin wires? 
>Scraping/sanding works fine for large wires but doesn't work too well 
>for thin wires.  
>
>Is there a chemical that will do the job (dip/wipe)? 
>
>I'm looking to wind some small toroid transformers (receive/low power) 
>and need to strip the wires close to the core after I have would the 
>transformer. 
>
>73, 
>
>   ... Joe, K4IK 
> 
>
>_______________________________________________
>Amps mailing list
>Amps at contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>  
>