[Amps] AL-80B unusual plate current behavior

[R.Measures]

On Mar 8, 2005, at 1:34 AM, Rick and Theresa Low wrote:

> Several times in the past week I䴜ve observed unusual behavior from 
> this single 3-500Z amplifier and need to know if this looks like the 
> tube is about to go belly up on me, or if there is some circuit factor 
> that䴜s causing this behavior:
>
> 1. First turn on, plate current indicates about 200-250 mA without 
> amplifier going into transmit mode.

My guess is a filament to grid short since 250mA on standby sounds like 
0v bias and it's normally c. 25v on Standby.  I would test the grid-fil 
BD voltage with a high-pot to find out what's what. .

> I turn ON with the standby switch in STBY. Stays this way for about 3 
> to 5 seconds, then zero current.
>
> 2. At seemingly random times during T/R operation, plate current meter 
> shows same 200-250 mA, input circuit shows HI SWR on the driver rig, 
> and of course, no RF output. Cannot clear by cycling T/R relay---PTT. 
> I turn off, wait about 10 seconds minimum, then turn on and get the 
> same ‰¥þFirst turn on‰¥ÿ behavior above.
>
> De Rick I0/N6CY Gaeta IT JN61sf
>
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>

Richard L. Measures, AG6K, 805.386.3734.  www.somis.org