[Amps] how to figure out solid state rf bias
Dan Sawyer
dansawyer at earthlink.net
Sun May 15 00:36:34 EDT 2005
All,
I have a couple of RF amps pulled from medical equipment. The power
circuit is straight forward. However I am looking for advice on how to
figure out the bias circuit. The power transistors are 24 volt. Is there
a way to safely approach how to establish an input voltage for the bias
circuit?
Does anyone out there have an example of a circuit diagram for this type
of amp?
Thanks,
Dan
More information about the Amps
mailing list