[Amps] SB200

[R.Measures]

Jim -- Possibly residual magnetism in the relay. Try reversing the 
polarity to the relay coil and cleaning the NC contacts.
end

On Nov 2, 2005, at 3:45 PM, Jim Vohland wrote:

> Hello all, new to list and posting first time. Have a sb200 which has 
> been
> acting up a bit. Set up is Icom 751A driving the sb200 via ampkeyer
> interface.
>
> Has developed intermittent problem (is there any other kind) where when
> transmitting and the mike is unkeyed, the receive stays dead. Thought 
> I had
> a bad jumper but replaced and it went back to same problem. Wiggling 
> the
> coax's will cause the receive to go in and out. I am not too much of a 
> tech
> and have the amp over at a friends for work but just wanting to get a 
> feel
> for what the experts say. Thinking possiblity of relay contacts or 
> perhaps a
> bad solder joint somewhere in the so239 areas. Any ideas?????
>
> _________________________________________________________________
> On the road to retirement? Check out MSN Life Events for advice on how 
> to
> get there! http://lifeevents.msn.com/category.aspx?cid=Retirement
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>

Richard L. Measures, AG6K, 805.386.3734.  www.somis.org