[Amps] sb-200 HIGH swr on output- HELP!

[HAROLD B MANDEL]

It sounds like your T/R relay contacts are dirty. That's the
first place I'd check. If it's an open frame relay it's probably the
culprit.

For testing purposes always use a dummy load.

Keep the other hand in your pocket.


Hal
W4HBM
On Mon, 21 Nov 2005 22:10:56 -0500 ashley newell <anewell at alltel.net>
writes:
> hi all,
> i have an sb-200, that has all the harbach mods etc., that has been 
> in 
> storage for a few years.
> i hooked it up to my station, and with a small amount of drive, the 
> 
> output swr is off the scale!!
> with the amp turned off, and signal running through it, i have abt a 
> 1.4 
> to 1, which is the antenna swr.
>  any help?
> 
> de kn4nn
> -- 
> 
>
=========================================================================
=======
> 
>   J. ASHLEY NEWELL                          
> 
>   anewell at alltel.net
> 
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
> 


Harold Mandel
Const. Supt.
Baran/Greenville
606 - 205 - 0172
hmandel at barantelecom.com