[Amps] Plate impedance

[Bill Turner]

ORIGINAL MESSAGE:

At 06:07 AM 4/10/2006, R at contesting.com;Measures wrote:

>A factor of 1.8 is close enough.  The exact factor is dependent on
>ZSAC, so there is no magic number written in stone.

*********** REPLY SEPARATOR ***********

Correct me if I'm wrong, but isn't the factor - 1.8 or whatever - 
only a starting point to get the design close to the desired Q? As I 
understand it, if you get the number a little bit "wrong", the only 
effect is to shift the final Q slightly. Is this correct?

73, Bill W6WRT