[Amps] Part needed

[Will Matney]

Ken,

Yes I'll take a look at Mouser. Some companies don't show everything they stock in their catalogs so Allied could handle them, but don't show them.

I almost forgot this, the type of connector it is and dimensions;

It is a 6/12 connector with 6 top and 6 bottom contacts.

The contact spacing is 0.156" on center.

They make different center spacings so that would be needed. I think 0.156" is about as big as they make them.

Thanks,

Will

*********** REPLY SEPARATOR  ***********

On 4/14/06 at 11:00 PM K. Indart wrote:

>Will,
>   Have you tried Mouser Electronics; check them on Web.  If they don't
>have
>what you are looking for, it does not exist !
>73, Ken,  WA4RPH     No minimum qty requirement, either.
>
>-----Original Message-----
>From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com]On
>Behalf Of Will Matney
>Sent: Friday, April 14, 2006 10:35 PM
>To: amps at contesting.com
>Subject: [Amps] Part needed
>
>All,
>
>I have a project here that I need a 6 position card edge connector for.
>This
>being the kind that plugs over traces on the edge of a PC board like in the
>back of a main frame. I need one that is chassis mount with the two ears on
>each side for screws. Everything I've found in Allied, and on ebay are 10
>positions and up. If anyone has one or two for sale, please contact me off
>the list. Thanks to all in advance.
>
>Best,
>
>Will
>
>_______________________________________________
>Amps mailing list
>Amps at contesting.com
>http://lists.contesting.com/mailman/listinfo/amps