[Amps] RFI Question
m.ford
k1ern at direcway.com
Fri Feb 3 21:03:48 EST 2006
Hello Mike,
How close is your neighbor? What model radio are you using
and is the output resonably clean?
If the output is ok and the neighbor is close enough, I would
invest in decent amplifier. Actually, at that low a power level
you may have an antenna issue, grounding issue etc.
I had a heathkit IR motion detector light in the yard that would
come on everytime I keyed. I did'nt know about it until the neighbor
mentioned it years later.
Buy the amp.
Mike k1ern
>
>
> ----- Original Message -----
> From: "K6QD" <K6QD at cox.net>
> To: <amps at contesting.com>
> Sent: Friday, February 03, 2006 4:22 PM
> Subject: [Amps] RFI Question
>
>
>> I don't know if this is the correct forum for my question, so if not, I
> apologize.
>> I have a friendly neighbor who has recently installed new light dimmer
> controls on three lamps. I am causing his lamps to go on & off when running
> any power over 100W on all HF bands. I had not seen this type of dimmer
> before, but it is a small (2" x 2" x 3/4") plastic box with 4 leads exiting.
> The 4 leads go to 1) 115 hot, 2) 115 neutral, 3) 115 to the lamp and 4)
> control lead to the metallic base of the lamp. By momentarily touching the
> lamp base one can set the brightness to 3 levels as well as off. Opening
> the box, I find one IC (8-pin mini-dip), one TO-220 (appears to be a pass
> transistor - nomenclature: "BT136", "600D") and multiple R, C & diodes on a
> single-sided PCB. There is no reference to the manufacturer other than
> "China". I can generally understand how the device works even though I
> cannot reference what the IC is. The IC nomenclature is "DI-2417" &
> "C4841917-6A". Has anyone had any experience correcting an interference
> problem with one of these type de
>> vices? Thanks! Mike K6QD
>> _______________________________________________
More information about the Amps
mailing list