[Amps] amp hardware

[Tim Long]

That would be ideal but not necessary.  Stainless steel is just fine, 
stronger, and more readily available.  Avoid aluminum to copper and 
aluminum to brass contact.  Good luck with your project.  73, Tim, W2UI

Steve Flood wrote:
> If I'm building up an amp (the RF compartment particularly) with aluminum sheet and angle stock, should I be using aluminum bolts/nuts/washers to avoid galvanic corrosion?
>
> Steve, KK7UV
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>