[Amps] 8877 blower requirement -airflow switch

[hamko2ok at optonline.net]

Henry used Rotron Air Flow Switches, which were made in Woodstock NY.

I found one recently model 2A that I used for a Dayton blower in my homebrew 6m 8877 amp.
I had to drill a hole  in the blower for the vane to stick through, copying the Henry version in my Henry 3K-X.
On the side of the aif flow switch it states:
This switch will actuate in an increasing vertical-up air stream no greater than the ft./min. figure marked on vane.  The 2A kit originally had multiple vanes so you could choose the one that actuated at your desired air flow.
In 1986, Rotron became Comair Rotron and the company moved to San Diego in 1990. It is owned by Howard Industries, which is based in CT. 

I found a page on the Ametek Rotron that describes this kit better, at: http://www.ametektip.com/ametek/pdfs/system.pdf

I don't know where to buy locally though.
Good luck.
Bennett ko2ok