[Amps] PLnetwork

[Bob Maser]

Bigger is better than smaller.  If you have the room,  you can wind your 
own. With a plate load impedance of 2200 ohms you will need ±20uH.  A better 
idea would be to find a Gates edge wound inductor.  It already has the 
rigidity and the mounting hardware is in place.  I'm thinking of one with a 
5" diameter, about 8" long.

Bob W6TR
----- Original Message ----- 
From: "Linda/John" <ljdoyle at suscom-maine.net>
To: <AMPS at contesting.com>
Sent: Monday, February 05, 2007 5:02 PM
Subject: [Amps] PLnetwork


> Hello again.. Due to an omission on my part I inadvertally did not mention 
> the Pl network was for a monoband 160m amp using a 3cx3000a7 some would 
> say 3X3 hi..What size copper tubing is recommended??I have a 50' roll of 
> 5/16 but I almost think thats overkill I'd like to know what the GURUs 
> recommend..thanks John K1GUN...
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps