[Amps] Commander plate voltage readings ?

[John Lemay]

Hugh

I think you are entirely correct. When I bought a Commander amplifier a few
years ago, the first thing I had to do was to replace that chain of
resistors. Good luck !

John G4ZTR

-----Original Message-----
From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com] On
Behalf Of hduff at cogeco.ca
Sent: 16 July 2007 19:49
To: amps at contesting.com
Subject: [Amps] Commander plate voltage readings ?

Is there a known issue with low plate voltage readings on Commander
amplifiers ?
A friend of mine owns a VHF-1200 and a VHF-2000.  Both read quite low on the
front panel plate voltage meter. i.e. 1900v
on the meter while an HV probe shows it to be more like 2600v.
It would appear the voltage divider resistors changed through
age/overheating stress. Seems like a bit of a job to
change them out since they're buried in the internally accessible input
compartment.

73 de Hugh VA3TO
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps