[Amps] Looking to purchase a good 6 meter amplifier

[jeremy-ca]

In linear service 1000W AM input is around 300W out, within the ratings of 
the tubes.

Carl
KM1H


----- Original Message ----- 
From: "Bill Fuqua" <wlfuqu00 at uky.edu>
To: <PJPilot at aol.com>; <amps at contesting.com>
Sent: Monday, July 30, 2007 3:46 PM
Subject: Re: [Amps] Looking to purchase a good 6 meter amplifier


>I just looked at the specifications for the Swan Mark VI  which had a pair
> of 4-400Z tubes originally.
> Oddly enough it states that I operate at 1000 watts continuous DC plate
> input power on CW, RTTY and AM.
> 1000 watts AM is 4000 watts PEP plate input power, far beyond the 2000
> watts PEP plate input power that it state for SSB.  Did they figure the 6
> meter band was wide enough that all that splatter would not matter?
>
> 73
> Bill wa4lav
> .
>
> At 03:09 PM 7/30/2007 -0400, PJPilot at aol.com wrote:
>>Would like to buy a good 6 meter amplifier that could handle 40 watts of
>>drive and give me about 350 watts of AM carrier power. ie: Henry 2006, or
>>a Swan
>>Mark 6, or a TEMPO 6&2, Commander 1200, or an Acom1000.
>>Contact : W7PJS @ _pjpilot at aol.com_ (mailto:pjpilot at aol.com)  TNX@  73's
>>
>>
>>
>>************************************** Get a sneak peek of the all-new AOL 
>>at
>>http://discover.aol.com/memed/aolcom30tour
>>_______________________________________________
>>Amps mailing list
>>Amps at contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>