[Amps] SB200 4.1 volts

John Becker johnb3030 at comcast.net
Wed May 2 06:45:00 EDT 2007


> Date: Tue, 1 May 2007 22:35:31 +0200
> From: "roller" <roller at comtech-data.se>
> Subject: [Amps] (no subject)
> 
> anyone with an ide how my sb220 could have 4.1volt in stead of around 5v AC ?? i tried to pull one tube out,but it increasted to 4.3volts..someone?
> 
> //SM7TVJ

When I was in college, we had a Hunter Bandit 2000 at the club station. 
At some point it lost a lot of power output. In troubleshooting it, we 
discovered obvious cold solder joints where the wires of the filament 
choke went into the solder lugs that terminated the assembly. After 
re-soldering them, the amp put out more power than it did when it was 
brand new!

Check every connection in the filament circuit.

73,

John, K9MM


More information about the Amps mailing list