[Amps] Blowers for metal-ceramic tubes

jeremy-ca km1h at jeremy.mv.com
Sat Sep 1 19:22:00 EDT 2007


Good work Ian.

Ive been using the nice technical information plus charts published by Bill 
Orr, W6SAI, in the Sept 1967 QST. A very informative article a bit over 6 
full pages. It also uses several tubes as examples that are still very much 
with us for homebrewing.

Carl
KM1H



----- Original Message ----- 
From: "Ian White GM3SEK" <gm3sek at ifwtech.co.uk>
To: <amps at contesting.com>
Sent: Saturday, September 01, 2007 1:21 PM
Subject: [Amps] Blowers for metal-ceramic tubes


>I have posted an Excel spreadsheet that will estimate the performance of
> a centrifugal blower from the wheel diameter, width and rpm.
>
> This can be compared with the requirements for any particular tube,
> using the manufacturer's data for the required volume flow rate and
> pressure.
>
> The spreadsheet uses the method published by G8WRB, and is on the
> website below. (Try to live with the mixed units, Carl  :-)
>
>
> -- 
>
> 73 from Ian GM3SEK
> http://www.ifwtech.co.uk/g3sek
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 



More information about the Amps mailing list