[Amps] how to measure tank

[George Badger]

Lynn
Put a resistor from plate ground to simulate the load and look into the output with an MFJ 259. Tune for a match. Works like a charm.
George    W6TC


----- Original Message ----
From: Lynn Osterbur <no9z at yahoo.com>
To: amps at contesting.com
Sent: Saturday, November 29, 2008 6:50:47 PM
Subject: [Amps] how to measure tank

I am starting to forget all I know!

Components  Homebrew amp and cushman service monitor

What is the proper way to measure a pi network with a tracking generator and spectrum analyzer.
I am mostly interested in the connections to the tank circuit.

using cushman 5100 with tracking generator and spectrum analyzer.  I havent used it for 
3 or 4 years and that was on a set of 2m bandpass filters.  I also assume that I will need to
put a load resistor across the tube equal to the load resistance.

Lynn NO9Z


      
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps