[Amps] 1/4" shaft connectors

[Robert Morris]

No one said they have to be round. I used 1/2" square stock, cut off an 
inch, drilled a 1/4" hole, tapped for the 6-32 screws.

Glen Zook wrote:
> Frankly, you can make you own couplers for just a few cents each from copper tubing that has an inside diameter of 1/4 inch.  Cut off a length about 1 inch long and then drill a hole near each end.  Then "tap" that hole for a machine screw.
> 
> Now you will need a tubing cutter which is just a few dollars at any home improvement center, a drill and bit, and a tap.  However, these tools are already in the possession of just about any amateur radio operator who does any building at all.
> 
> Glen, K9STH
> 
> Website:  http://k9sth.com
> 
> 
>       
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.