[Amps] 240V Outlet

[Jim Brown]

--Original Message Text---
From: Gudguyham at aol.com
Date: Tue, 11 Aug 2009 07:43:59 EDT

In a message dated 8/11/2009 3:28:13 A.M. Eastern Daylight Time, 
jim at audiosystemsgroup.com writes:

NO. NO! NO! The advice quoted below is NOT mine. My post took strong 
exception to the advice quoted below. 

>You should not change the outlets. NEMA 5-20P plugs come installed 
>only on equipment drawing just under 15 amperes up to 20 amperes. 
>If the equipment draws this much current, it should have a 
>dedicated circuit. Using NEMA 5-20R receptacles for general purpose
>outlets invites you to easily overload the circuit. All you have to
>do is plug in two items using this configuration.

In response to the above, I said:

You have a rather limited view of a world that far more varied than 
you imagine. I work in the world of pro audio, and there are many 
occasions where a product may be rated for 20A service but have very 
dynamic load requirements and draw FAR less current in real world 
applications. Audio power amplifiers are a good example -- a big 
power amp may draw 15-18A with both channels near clip on sine waves 
or very dense audio, but operating them under those conditions would 
be VERY rare outside of a test lab. Another example is a series mode 
surge suppression rated for 20A, with a 20A plug. There are MANY 
other examples that could be cited, none of which justfiy a 
dedicated circuit for a single product ONLY because it has a 20A 
plug.

73,

Jim Brown K9YC