[Amps] Cleaning Cigarette tar....?
km1h at jeremy.mv.com
Fri Jul 31 17:13:33 PDT 2009
Ive had good luck with Scrubbing Bubbles and the usual collection of
toothbrushes, artist brush, toothpick, paper towels, etc.
The usual caveats apply also.
----- Original Message -----
From: "mikea" <mikea at mikea.ath.cx>
To: <amps at contesting.com>
Sent: Friday, July 31, 2009 7:42 PM
Subject: Re: [Amps] Cleaning Cigarette tar....?
> On Fri, Jul 31, 2009 at 04:05:16PM -0700, Jim Barber wrote:
>> Garden-variety "Formula 409" spray cleaner works for me. I've had good
>> luck soaking cases, chassis etc. with it for 15 minutes or so, then
>> either rinsing with clear water or wiping down with a fresh misting of
>> 409 and cotton towels.
>> Common-sense rules apply of course, but I've never had a reaction or
>> staining problem with it.
> The only caveat I'd put on the above is that I have seen 409 eat epoxy
> paint very slightly (on military comms gear, back in 1970). I don't know
> if the formulation has changed, and haven't had contact with the gear
> since I was debriefed. I suspect it's not a concern in this particular
> situation, but wanted to make you aware, Just In Case.
> Mike Andrews, W5EGO
> mikea at mikea.ath.cx
> Tired old sysadmin
> Amps mailing list
> Amps at contesting.com
More information about the Amps