[Amps] Need bushing

[TexasRF at aol.com]

If you have a drill press and vise, you can make one in a few minutes. A  
one inch section of a .75" bolt makes the donor material. Drill through the  
center .25" and then drill again half way .375" diameter. Set screws can be  
added by drilling one side and tapping 6-32 or 8-32.
 
A .25" bolt and nut makes a nice mandrel to chuck the piece in the drill  
press for smoothing the ends and removing burrs.
 
73,
Gerald K5GW
 
In a message dated 10/5/2009 8:34:26 P.M. Central Daylight Time,  
k7rdx at charter.net writes:

Ampers:  Looking for a bushing to adapt 3/8"shaft to 1/4"...Needs to be 
solid not a  flexible coupling..If anyone has such and will part with it please 
contact me  off list..Many  thanks..Jim..K7RDX..
_______________________________________________
Amps  mailing  list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps