[Amps] Checking Plate Choke resonance

[Carl]

Yep, the principle works from power supplies, audio and RF.

I believe Bill is the one confused.

Carl
KM1H


----- Original Message ----- 
From: "Jeff Blaine AC0C" <keepwalking188 at yahoo.com>
To: <dezrat1242 at yahoo.com>; <amps at contesting.com>
Sent: Tuesday, October 13, 2009 9:07 PM
Subject: Re: [Amps] Checking Plate Choke resonance


> Hi Bill,
>
> I am a bit confused on this.
>
> It's been a while - but I was thinking that I read one time on RM's site
> about creating an intentional parallel resonance on the filament choke.
> That's a different part, but it seems the principle would be the same.
>
> 73/jeff/ac0c
>
> --------------------------------------------------
> From: "Bill, W6WRT" <dezrat1242 at yahoo.com>
> Sent: Tuesday, October 13, 2009 11:03 AM
> To: <amps at contesting.com>
> Subject: Re: [Amps] Checking Plate Choke resonance
>
>> ORIGINAL MESSAGE:
>>
>> On Mon, 12 Oct 2009 23:17:39 -0700, "Hardy Landskov" <n7rt at cox.net> 
>> wrote:
>>
>>>Sweep
>>>the frequency range you want to use and watch for series resonances.
>>
>> REPLY:
>>
>> Watch for parallel resonances too. Either one will smoke the choke if 
>> they
>> are
>> in or near a ham band.
>>
>> 73, Bill W6WRT
>> _______________________________________________
>> Amps mailing list
>> Amps at contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps