[Amps] TL922 Power Plugs

[Bill]

Gary Smith wrote:
> And in California. I would check that out.  You may got a short (!) trip you might not want.
> 73,
> Gary...wa6fgi
>
>
>   ----- Original Message ----- 
>   From: markrob at mindspring.com 
>   To: Doug Renwick ; amps at contesting.com 
>   Sent: Thursday, October 29, 2009 11:20 AM
>   Subject: Re: [Amps] TL922 Power Plugs
>
>
>   Yes it is even the practice here in NC
>
>   Mark
>
>   -----Original Message-----
>   >From: Doug Renwick <ve5ra at sasktel.net>
>   >Sent: Oct 29, 2009 2:03 PM
>   >To: amps at contesting.com
>   >Subject: Re: [Amps] TL922 Power Plugs
>   >
>   >Your white neutral had better be connected to the ground at the service
>   >panel ... that is the correct practice here in  NA.
>   >
>   >Doug
>   >
>   >I'll run the race and I will never be the same again. 
>   >
>   >-----Original Message-----
>   >From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com]
>   >On Behalf Of markrob at mindspring.com
>   >Sent: October 29, 2009 9:24 AM
>   >To: Robert Groh; allanws at n9isn.com; amps at contesting.com
>   >Subject: Re: [Amps] TL922 Power Plugs
>   >
>   >In fact in my house all the Neutral wires are connected to the gnd bus
>   >bar at the service panel
>   >
>   >Mark N1UK
>   >
>   >
>   >
>   >_______________________________________________
>   >Amps mailing list
>   >Amps at contesting.com
>   >http://lists.contesting.com/mailman/listinfo/amps
>
>   _______________________________________________
>   Amps mailing list
>   Amps at contesting.com
>   http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>   
It is part of the NATIONAL Electrical Code....   Safety Ground and 
Neutral must be bonded in the entrance panel - and ONLY in the entrance 
panel(*).  There may be variants for commercial, but that's current code 
for residential.

* = if you run a branch circuit, the Safety Ground and Neutral must not 
be bonded... the Neutral must go to its own bus not connected to the 
frame or Safety Ground.

Bill  N2BC