[Amps] Input SWR
vk3pa at vk3pa.com
vk3pa at vk3pa.com
Fri Sep 11 18:55:50 PDT 2009
Quoting Dan <n5ar at air-pipe.com>:
> I believe you are correct Tomas. The amps I have used do not usually
> show a very low input SWR over the entire band, particularly the wider
> bands.
> 73, Dan, N5AR
> Try feeding into a 50 ohm dummy load es see if ok es also try
> differant length of feed cable between amp es tranceiver..
>
Tomas Hood wrote:
>> Another question:
>>
>> When I am bypassing the amp (amp is in Standby mode), the SWR reading
>> on my Icom IC-7000 exciter shows nearly 1:1 through the amp into the
>> antenna tuner/matching network. When I switch from Standby to Operate
>> mode (Ameritron AL-80A), the SWR reading moves closer to 1.4:1 - is
>> this an indication that the input stage of the amp needs to be
>> aligned?
>>
>> I am very new to this amp world... thanks for helping me get my bearings...
>>
>>
>> ------------------------------------------------------------------------
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - www.avg.com
>> Version: 8.5.409 / Virus Database: 270.13.91/2363 - Release Date:
>> 09/11/09 09:15:00
>>
>>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
More information about the Amps
mailing list