[Amps] ripple in B+ supply.

[Ian White GM3SEK]

Jim Thomson wrote:
>##  where psud falls  down.. is with dynamic loads. I wish they could 
>simulate that.  The original psud  was  for audiophile and stereo amp 
>fellows.  I see the latest version will allow  a cap up to 1 farad.
>

PSU Designer will simulate a constant-current load which can step to a 
different value after a specified period of time. This allows you to 
simulate two levels of current draw and the worst-case step response 
between them. The two currents are usually either off-load followed by 
zero-signal anode current, or ZSAC followed by full key-down.



-- 

73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek