[Amps] Thp HL-2k

[pfizenmayer]

Are you sure the power peak is on 75 meters and not on 40 meters with the PA 
trying to double to 40 ? The plate tuning going to minimum capacitance is 
suspicious.(And I assume you really mean plate tuning not the loading cap ) 
What is your load SWR while you are doing this ? Better yet use a dummy load 
with known good swr - BUT still make sure the output is on the band you are 
expecting ..

73 de hank K7HP

----- Original Message ----- 
From: "MIKE DURKIN" <patriot121 at msn.com>
To: "amps fourm" <amps at contesting.com>
Sent: Wednesday, September 15, 2010 10:40 AM
Subject: Re: [Amps] Thp HL-2k


>
> Check that ..... its not burning off the contacts like last time !!!!!
>
> While set to operate on 75/80M - as the plate TUNE was being decreased ( 
> to almost minimum value) , power was still increasing -
> again around 900W the problem shows its self and im not sure why. It looks 
> like it is arcking from the 75M extra tune cap ( C 44 ) contact to the 15M 
> coil contact. They are just across the air gap from each other.
>
> Any one seen this before??    Maybe sticking some ceramic insulator 
> between the two .. don't know.
>
> Mike
> KC7NOA
>
>
>
> From: patriot121 at msn.com
> To: amps at contesting.com
> Subject: Thp HL-2k
> Date: Sun, 12 Sep 2010 08:37:12 -0700
>
>
>
>
>
>
>
>
> Has any one had issues with the HL-2K from THP - like acrking/vaporizing 
> contacts on 75M....
>
> Iv blown off the contacts again - as the plate loading was being 
> decreased, power was still increasing - again around 900W the problem 
> shows its self and im not sure why. I haven't opened the amp yet to verify 
> that the 75M & 40M contacts are cooked - im just guessing an ark from the 
> 40m to the 75M ...... because the contacts were new and no groove was seen 
> in the sliding plate. Q to high?? mabey decrease the tank coil by one turn 
> ..??
>
> Mike
> KC7NOA
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>