[Amps] MRFE6VP Datasheet

[Roger (sub1)]

On 8/21/2011 5:18 AM, Peter Frenning [OZ1PIF] wrote:
> Den 21-08-2011 10:54, Roger (sub1) skrev:
>> On 8/21/2011 3:56 AM, David Shapiro wrote:
>>> Someone requested the datasheet.
>>>
>>>
>> This causes me to reflect on that 1200 watt output rating a bit.  They
>> emphasize that the 1200 watts is "pulsed" at 100 uSec width and 20% duty
>> cycle.  Then they also list 1200 W out CW.  I don't see how they can get
>> both.
>>
>> On the positive side they do operate with a case temp as high as 150C.
>> BUT they also say they higher the case temp the shorter meantime between
>> failures.  It also appears to be operating class C.
>>
>> I've not taken the time to really look at the curves, but it appears at
>> a glance that to operate one in a linear fashion would only result in a
>> few hundred watts out per device.  So, using them as most devices are
>> presently used in amateur service (4 in PP parallel) would give about a
>> KW out at a cost of about $1,000 in devices, not counting other components.
>>
>> Devices are improving and great strides have been made, but those I've
>> talked with who have reached the testing stages found their main
>> roadblocks were cooling. The small heat transfer area of the device
>> makes it difficult to get a decent transfer and keep the delta T down to
>> a point where the device does not self destruct.
>>
>> 73
>>
>> Roger (K8RI)
>>
> Some data points to ponder can be found here: 
> http://www.frenning.dk/OZ1PIF_HOMEPAGE/LDMOS_SSPA.html describing my 
> newly "almost completed" 144MHz amp using this device (singly). I run 
> it fairly conservatively at ~900W out with good reports and so so 
> measuments.
>
Very nice looking piece of work.

73

Roger (K8RI)
> -- 
> Vy 73 de OZ1PIF/5Q2M, Peter
>
> *****************************************
> ** Genius is one per cent inspiration, **
> ** and ninety-nine per cent            **
> ** perspiration.                       **
> **               -- Thomas A. Edison   **
> *****************************************
> email: peter(no-spamfiller)@frenning.dk
> http://www.frenning.dk/oz1pif.htm
> Ph. +45 4619 3239
> Snailmail:
> Peter Frenning
> Ternevej 23
> DK-4130 Viby Sj.
> Denmark
> *****************************************
>