[Amps] ICOM PRO III QSK

[Jim W7RY]

the PRO III uses a relay for the send jack. I always use the T8V from one of 
the aux jacks to key my amplifiers. I'm sure the relay in the PRO III is 
pretty fast, 4-5 ms, but every little bit counts.

I not sure I have measured the timing between T8 going high and actual RF 
output. But it is probably about 8ms.

73
Jim W7RY



--------------------------------------------------
From: "rick darwicki" <n6pe at yahoo.com>
Sent: Wednesday, December 07, 2011 11:12 AM
To: <amps at contesting.com>
Subject: [Amps] ICOM PRO III QSK

> Hi all,
>
> Does anyone know it the timing on the ICOM PRO III linear amplifier SEND 
> line is such that the AMP will not be hot switched on FULL BREAK IN?
>
> I have an old Alpha 76 and can install vacuum relays for QSK if the timing 
> is OK out of the PRO III.
>
> Thanks,
>
>
> Rick, N6PE
> =============================================================================
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps