[Amps] ten tec Hercules,,II,,

[krishna kanakasapapathi]

Bill,
I have seen postings about getting rid off the molex and instead using 
the Anderson powerpole connector.
You will need to use the smaller(600v/50Amp) type. It fits in the slot 
when you remove the molex. I ordered
the 100amp connector only to find that it was too big. I did not swap 
mine out, since i was cutting it too close
for VU4PB and did not mess with the amp that close to the travel date. I 
don't have the amp with me here in W4.

However, folks that replaced the wiring with the new connector claim 
that it puts out close to 600W and draws
over a 100amp.

73s
krish
w4vku
On 5/9/2011 1:03 PM, Bill NY9H wrote:
> anyone know the molex part number of the series used for the DC power
> connector for the Herc II  ???
>
> I asked TT but the response was $50 is the cost for a 4 foot cord....
>
> tnx
>
> bill  ny9h
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>