[Amps] Replacing T/R Relay in AL-1200.

Al Kozakiewicz akozak at hourglass.com
Tue Feb 14 15:48:50 PST 2012


I did it on an AL-1500.  It came with photocopied, hand-written notes by Tom W8JI. 

It was simple.  I think I may have skipped drilling any holes and mounting the PCB with just two standoffs - I don't remember.  I think I had to "stretch" a single wire.

If the process is "graduate advanced calculus", I'm a f**king nuclear rocket scientist. With a Nobel prize.

Al
AB2ZY

-----Original Message-----
From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com] On Behalf Of Larry K4AB
Sent: Tuesday, February 14, 2012 6:41 PM
To: amps at contesting.com
Subject: [Amps] Replacing T/R Relay in AL-1200.

I need to replace the old 3PDT relay in an Ameritron AL-1200. Luckily, Ameritron sells a PCB relay assembly which replaces the clunky old relay with a more modern, faster relay.

In looking at W8WWV's website he describes replacing the old relay with the new assembly as "graduate advanced calculus" and estimates the time to do the mod at roughly 8 hours, requiring drilling 3 holes, etc.

To further complicate matters, the tech at Ameritron I spoke with says the new assembly comes with no instructions...not even a schematic!

On the other hand, another amateur I emailed said it was easy to do, about
1 hour.

Can anyone else who's done this procedure offer any additional insights?
Anyone
make any notes when installing the mod?  Thanks!

73,
Larry K4AB
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps


More information about the Amps mailing list