[Amps] AL-1200 no output

[Stein Roar Brobakken]

Hi

It was a diode on the HV board.. bad soldering 

73s LA6FJA Rag

-----Original Message-----
From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com] On
Behalf Of Richard Solomon
Sent: Wednesday, February 15, 2012 11:49 PM
To: amps at contesting.com
Subject: Re: [Amps] AL-1200 no output

More likely, R3 has opened up.

73, Dick, W1KSZ

On Wed, Feb 15, 2012 at 3:44 PM,  <Gudguyham at aol.com> wrote:
> Good point, no idle current could mean relay problem or a dead tube.
>
>
> In a message dated 2/15/2012 5:36:29 P.M. Eastern Standard Time, 
> km1h at jeremy.mv.com writes:
>
> What is  the idle current with no drive? Does the antenna relay  switch?
>
> Carl
> KM1H
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps