[Amps] Hunter 2000c

[Tim Kass]

It is a simple amp, doubt that both filaments would go out at the same time..the transformer has all the windings on it, HV, filament, bias, so hope its not your transformer.. had 2 of these in the past, still have one, my primary amp, wonderful amp, built tough, similar to Collins since the designer was an engineer at Collins before he started Hunter Electronics..

73, Tim K8WBL

--- On Fri, 6/8/12, Carl <km1h at jeremy.mv.com> wrote:

From: Carl <km1h at jeremy.mv.com>
Subject: Re: [Amps] Hunter 2000c
To: "Charles Hedrick" <cchedrick at gmail.com>, amps at contesting.com
Date: Friday, June 8, 2012, 7:39 PM

Start with the manual and follow the circuit, its a good but very basic amp.

Carl
KM1H


----- Original Message ----- 
From: "Charles Hedrick" <cchedrick at gmail.com>
To: <amps at contesting.com>
Sent: Friday, June 08, 2012 6:03 PM
Subject: [Amps] Hunter 2000c


> Hi all,
> We'll it was fine the day before yesterday, but last night I turned it on
> relays closed on xmit and no output.  I looked and found the filaments 
> were
> not glowing so suspect that circuit has an issue.   I haven't put the 
> beast
> on the bench yet, but has anyone experienced such an occurrence that can
> advise a starting place rather than a full circuit chase?
> Thanks
> WA4JKW
> Cam
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2433/5056 - Release Date: 06/08/12
> 

_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps