[Amps] April QST article on RF power tube test stand

[Carl]

Ive outlined the steps several times on here under gettering, see the archives.

Carl
KM1H


  ----- Original Message ----- 
  From: Robert Groh 
  To: Carl ; amps at contesting.com 
  Sent: Sunday, March 18, 2012 11:38 AM
  Subject: Re: [Amps] April QST article on RF power tube test stand


  Carl,

  I would be very interested in your ideas on what should be added.  My opinion was also that it was a bit limited (keeping in mind my absolute beginner status in high power amps) and could stand a few additions such as easy provision for running lower plate voltage for gettering, some way to test emission, etc.  Also still needs some way to hipot the tube but I guess that is best handled with a separate hipot test setup.

  In any event, I would be most eager to hear your ideas.

  73
  Bob, WA2CKY




------------------------------------------------------------------------------
  From: Carl <km1h at jeremy.mv.com>
  To: Rob Atkinson <ranchorobbo at gmail.com>; amps at contesting.com
  Sent: Sun, March 18, 2012 10:30:24 AM
  Subject: Re: [Amps] April QST article on RF power tube test stand

  Its a mostly waste of time as built. A little more work and it could be 
  useful to do emissions tests as well as proper (safe) gettering.

  Carl
  KM1H



------------------------------------------------------------------------------

  No virus found in this message.
  Checked by AVG - www.avg.com
  Version: 10.0.1424 / Virus Database: 2113/4878 - Release Date: 03/18/12