[Amps] Small transformer evaluation
Vic K2VCO
k2vco.vic at gmail.com
Sat Sep 1 17:18:46 EDT 2012
I switched to capacitor input and changed the load to 5300 ohms. Now I am getting 438V and
83 MA. I stuck a fuse on the transformer just in case and I will let it run for a while.
It is noticeably warm but not uncomfortable to touch. If it can operate at this level it
will be fine for my project.
On 9/1/2012 1:37 PM, Vic K2VCO wrote:
> Some of you will remember that I was wondering about utilizing a small Philco power
> transformer (model 45-7011-7) for a screen supply. It puts out 380-0-380 vac plus 5 and
> 6 v for filaments. I have hooked it up jn a full-wave ct circuit feeding a choke-input
> filter and 20 uf capacitor. It is feeding a 4300 ohm 50w resistor for a load.
>
> I measure an AC voltage of 378v on either half of the secondary and 315v DC across the
> load (83% of the AC). Current is about 73 ma. It has been sitting for about 20 minutes
> and I can detect a very slight rise in temperature of the transformer. I am going to let
> it sit for at least an hour.
>
> I think that I am proving that I will be able to draw this much current, but the voltage
> is too low. Next I am going to try it as capacitor-input and see what happens.
>
>
> --
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco/
More information about the Amps
mailing list