[Amps] TL922 build-in new (vacuum) antenne relay

Vic K2VCO k2vco.vic at gmail.com
Mon Sep 24 19:16:17 EDT 2012


If I remember correctly, you have to remove both covers. You need to access the screws 
that hold it in from the top and take it out from the bottom. I suggest cutting the wires 
going to it first and labeling them, so you can more easily rewire it.


On 9/24/2012 12:12 PM, Behiels JeanPierre wrote:
>
>
> Hi;
>
> Could anyone explain how I can remove on the easyest way the originally build-in
> antenne relay of a old TL922 amplifier. I will change in this unit,to originally one
> by a vacuum type of Jennings. I could not find any information on that even not in a
> service manual of the equipment self !! All recomandations will be mutch appreciated
> concerning this subject. I think it is important to start on the good way,and not
> oppening the wrong cover to examine (above or down cover or both)
>
> Kindly regards Jean ON4AEF. _______________________________________________ Amps
> mailing list Amps at contesting.com http://lists.contesting.com/mailman/listinfo/amps
>

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/


More information about the Amps mailing list