[Amps] HP Blade power supply connectors

[Robert Friess]

I'll take a set.  Shipping will be to 95030.  How do I pay you?  PayPal?

Bob, N6CM



On Fri, Jul 5, 2013 at 5:48 PM, Dick Hanson <dick at dkhanson.com> wrote:

> Hi Mike....
> Yes, both the 240VAC connectors as well as the 50VDC and control pins
> connectors are available....tho not without some work.
> Here is an embedded Word doc for easier reading for you.
>
> I have a few of these connectors available if you'd rather not do the work
> of acquiring the backplanes and then removing the connectors.
> They are $15 for the pair plus shipping.
>
> 73,
> Dick, K5AND
> Austin, TX
>
> "There are two 'blade enclosure' units which can be salvaged for connectors
> etc.
> 274840-001 and 230769-001; the first one is a single phase unit and the
> last
> one is 3 phase.
> The only problem is that these things are big, heavy and come with bulky
> cabling attached.
>
> The DC output with its integral 20 pin control is easier to obtain by
> simply
> buying the 253381-001 backplane assembly.
> This will provide six DC output connectors as well as six 20-pin control
> connectors.
>
> The 20-pin control connectors have to very carefully removed from the PC
> motherboard.
> They are NOT soldered to the board; rather, they have 'compression' pins
> which have been forced into the board, thus making contact with the plated
> thru holes into which they mount.
> The tinned copper bus bar has to be cut out with a hacksaw, but once
> removed, you wind up with dandy heavy duty connecting lugs"
>
> -----Original Message-----
> From: Amps [mailto:amps-bounces at contesting.com] On Behalf Of
> mikflathead at aol.com
> Sent: Friday, July 05, 2013 5:41 PM
> To: amps at contesting.com
> Subject: [Amps] Blade power supply
>
> Is there an available connector to connect the input 220 and output 50 volt
> connectors to the outputs of these type power supply.
> A spade terminal kinda works but will not go on all the way do to the taper
> on the male lug. Any creative ideas out there?
>
> Thanks Mike
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>