[Amps] Molex Pins

[Val]

Farnell carries genuine Molex.  I have ordered pins and housings there, 
though only the 4 pin kind that is used by the new radios. Could check the 
PN in Monday.

73, Val LZ1VB


----- Original Message ----- 
From: "Bob K6UJ" <k6uj at pacbell.net>
To: "Amps reflector" <amps at contesting.com>
Sent: Saturday, March 30, 2013 5:34 PM
Subject: Re: [Amps] Molex Pins


> So our best bet is to order from Icom ?
>
> Bob
> K6UJ
>
>
> On Mar 30, 2013, at 8:29 AM, Jim W7RY wrote:
>
>> Cant buy them from Mouser. I too went through the exercise. And most of 
>> the plugs/pins that you buy on the net, (quick silver, The RFC etc) the 
>> female
>> pins are too big for the male pins of the radio.
>>
>> At The RFC, the pins the sell with the plugs that are a different 
>> configuration and wont plug into the radio, are fine.
>> But the pins they ship with the plugs that do plug into the radio, are 
>> too big and fit very loosely.
>>
>> Good luck!
>> 73
>> Jim W7RY
>>
>>
>> -----Original Message----- From: Col. Paul E. Cater
>> Sent: Saturday, March 30, 2013 6:16 AM
>> To: Amps reflector
>> Subject: [Amps] Molex Pins
>>
>> This is an obvious case of brain flatulence.  I have ordered 4 different
>> part numbers from Mouser for the *pins* only that fit the power 
>> connectors
>> on Icom and other rigs.  The standard 6 hole kind.  I still don't have 
>> the
>> correct size.
>>
>> Anyone have a part number for these off the top of their head?  Male &
>> female.
>>
>> Thanks,
>> Paul
>> WD8OSU