[Amps] DENTRON 160-10L QUESTIONS

[Robert Logan via Amps]

Hello Gary.

I picked up a used Amp Supply Co. LA-1000A amp recently and had the same problem.  It turns out the relay was clicking but the contacts that permitted the drive to go through we're not making contact.  One 'pin ' was bent a little too far out from the other.

I fixed it but it happened again after short use so I replaced the relay and it's worked perfectly ever since.  You might want to check continuity between all pairs of contacts when the relay clicks.  Bob NZ5A

Sent from my iPhone

On Aug 4, 2014, at 2:30 PM, gary mankoff via Amps <amps at contesting.com> wrote:

HELLO EVERYONE...
I JUST PICKED UP A DENTRON 160-10L...
WITH 2000 VOLTS ON THE METER AND ONLY 2 572B TUBES ,THAT I DONT KNOW IF THEY WORK ,AND WITH 100 WATTS DRIVE , THE AMP EVEN ISNT PASSING THE DRIVE POWER THROUGH IT ...
THE RELAYS CLICK AND THE FAN "TAKES OFF "
ALSO IS THERE A WAY TO USE 811A'S AT 2000V? 
ANY IDEAS? 
TU ES 73...
GARY...
N6BIZ...
PETALUMA CA...
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps