[Amps] 811's in a Clipperton L

[monk via Amps]

Check an see if the high voltage section is a doubler, if so wire it for a full wave or bridge. If it isn't a doubler check and see if the filament voltage is 6.3 or 12.6. If it is
12.6 ( two tubes in series) rewire the input to the transformer for 240 and run it on 120.
Then rewire the filaments all in parallel. You may have to re-tap your tank coils for the different high voltage.

                                                          Hope this helps
                                                          Wayne kd7rur

Woodland WA