[Amps] Amp Supply LK500ZB - strange failure mode

Jim W7RY w7ry at centurytel.net
Fri Oct 3 00:44:08 EDT 2014


Agreed!
73
Jim W7RY


-----Original Message----- 
From: Alek Petkovic
Sent: Thursday, October 02, 2014 8:25 PM
To: Amplifier Mailing List
Subject: Re: [Amps] Amp Supply LK500ZB - strange failure mode

See http://www.rfconcepts.com/PRODUCTS/tubes

They appear to be the best deal around.

73, Alek
VK6APK

On 3/10/2014 10:05 AM, k0zx Rich wrote:
> Right you were Colin. After pulling and swapping the result was one of 
> them had the symptom and the other didn't. Pretty clear cut. So I guess 
> I'm on the hunt for another, first price i've seen was 189, hoping can do 
> better than that. Thanx for the suggestion, I got focused in on possible 
> semiconductor failure, replaced the zener in the cathode path.
> Are u and owner of one of these amps?
> rich
>
>
> On 10/2/2014 9:07 AM, Colin Lamb wrote:
>>
>>
>> Hi Rich:
>>
>> Pull one tube and try it - then the other.  I suspect one tube.
>>
>> Tuning will change and the input swr will increase - but you are looking 
>> for an obviously bad tube.
>>
>> Assuming the filaments are not in series and the cooling is not solely 
>> through the socket, it will fire up fine.  Watch out for hv bite.
>>
>> 73,  Colin  K7FM
>>
>>
>> On 10/2/2014 7:59 AM, k0zx Rich wrote:
>>> Wonder if anyone has experienced this failure mode with this or a 
>>> similar amp:
>>>
>>> This amp is 80s vintage and since then has been a solid performer, 
>>> grounded grid with two 3-500z. But it has a developed a problem where at 
>>> power up (no rf drive, ant relay input not active for tx), the plate 
>>> current rises to about 3x normal (about 300ma, 100 is normal), stays 
>>> there for 5 to 10 seconds and then drops to zero.
>>> If enabled to transmit with  antenna relay input on, plate idle current 
>>> is normal, going from 0 to 100ma.
>>> If apply rf in, it will output but at only about .6 or .7 its normal 
>>> output.
>>> After inspecting the schematic am not seeing an obvious source for the 
>>> problem.
>>>
>>> Any suggestions appreciated
>>> Rich
>>> _______________________________________________
>>> Amps mailing list
>>> Amps at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>>
>>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>

-- 
>From Sunny Binningup


---
This email is free from viruses and malware because avast! Antivirus 
protection is active.
http://www.avast.com

_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps 



More information about the Amps mailing list