[Amps] SB-220 6 meter input network
Paul Baldock
paul at paulbaldock.com
Tue Jul 7 11:51:19 EDT 2015
I used a 6" piece of home made 30Ohm coax from the tubes to the
matching network. The pi network was 100pF trimmer on the input side,
a 40pF trimmer on the output side and an aprox .16uH coil.
- Paul
At 06:21 AM 7/7/2015, Steve London wrote:
>I am converting a previously-modified SB-220 to a 6 meter-only amp.
>
>The original input pi-network is long gone. Most of the articles on
>conversion say stuff like "remove N turns from the original 10 meter
>input coil". Can anyone tell me component values for the 2
>capacitors and the inductor for a 6 meter input network ?
>
>Thanks and 73,
>Steve, N2IC
>_______________________________________________
>Amps mailing list
>Amps at contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
More information about the Amps
mailing list