[Amps] Ldmos heat spreaders

[Kevin]

w6plq.com
Look in the "Parts I can supply" link on his page. Milled and drilled 
for the device and the heat sink.
He will flow solder, (recommended install method by Freescale and NXP) 
the device to the spreader if you desire.


On 8/12/2016 2:52 PM, Ian Swain wrote:
> Hi guys I'm building my first ldmos amp with a blf188xr and can't find a
> nice think slab of copper for a heat spreader
>
> I've only found up to 6mm think would this be okay ? Or could I get away
> with 2 layers to get 12 mm with heat transfer paste ?
>
> Any other zl stations or vk found a good copper source ?
>
> 73 de zl2ias
> All the best
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>

-- 
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus