[Amps] HIGH FILAMENT VOLTAGE
Richard Solomon
dickw1ksz at gmail.com
Sat Dec 10 19:34:11 EST 2016
You can also use Nichrome wire from
an old toaster or such.
BUT, before you go through this, make
sure the meter you use to measure the
Filament Voltage is accurate. Try making
the measurement with 2 or 3 other meters.
73 es HH, Dick, W1KSZ
On Sat, Dec 10, 2016 at 4:58 PM, kenneth Johnson <wa6rtp at hotmail.com> wrote:
> I used # 12 wire …total of 24 inches long wound in a two inch coil placed
> in each filament lead .
> this droped the voltage on my henry 2k-3 filaments into specifation.
> your problem is finding enough room to get the coil in there. at any rate
> …a length of wire is the way to go.
> Sent from Windows Mail
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
More information about the Amps
mailing list