[Amps] EIMACRe: Tube Tester

[finalact@embarqmail.com]

EIMAC




On 6/10/2016 9:38 AM, Scott via Amps wrote:
> Hi Joe,
>   
> I have used them this year to test a few 8874s and 3cx800's and found them
> to be quick, reliable, and the results generally consistent with what I
> already  knew or was told about the tubes, and the tubes came back clean and
> well  protected.
>   
> I was a little concerned when I was told in an email not to worry about
> gettering the tubes -which I did anyway first, as well as continuity and few
> thousand volt hi pot test just to be sure I wasn't sending an obviously bad
> tube  in - but based on my experience would recco them.
>   
> YMMV of course.
>   
> 73 Scott
>   
>   
>   
> In a message dated 6/10/2016 9:03:50 A.M. Central Daylight Time,
> nss at mwt.net writes:
>
> Greetings Everyone,
>
> My first Official posting.
>
> Is  anyone familiar with this offer on E-Bay to test  tubes?
>
> http://www.ebay.com/itm/Power-Tube-Testing-Service-Low-Power-Eimac-Electron-
> Tubes-8877-8874-4CX250B-/291362633865
>
> Or  anyone else that can test power tubes?
>
> No sense building an amp around  a tube, if you are not totally sure the
> tube is good.
>
> Joe  WB9SBD
>
> _______________________________________________
> Amps mailing  list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus