[Amps] Operational Input Impedance
Jim Brown
jim at audiosystemsgroup.com
Sat Dec 23 17:46:36 EST 2017
I don't know the microHam unit, but I use the LP-100A with two
detectors, one on each power amp in my SO2R setup. One of the features
of its firmware is that in this setup, it can be set to automatically
switch the readout to the active transmitter. And yes, it will do
exactly what Joe describes. It's an excellent unit. Larry ships his
detectors factory-calibrated to a pair of BNC cables that connect each
detector to the unit. I bought a used unit from W6OSP's estate that came
with a single detector. I added a second detector, and sent the unit
back to Larry for calibration.
73, Jim K9YC
On 12/23/2017 2:23 PM, Joe Subich, W4TV wrote:
> microHAM SMORF and N8LP LP-100A will provide calibrated R+/-jX for
> this application. SMORF will allow "calibrating out" a known distance
> of standard cables. Either unit has a remote sensor unit that can
> be connected to the input jack of the amplifier under test with a
> simple double female connector (essentially zero length line).
More information about the Amps
mailing list