[Amps] Ten-Tec Titan 10 Meter Input SWR

[Jim Brown]

Exactly the right question to ask.

Another point. SWR is established by the match at the RX end of the 
line, NOT at the TX end. Yes, the line can transform the Z, but the SWR 
along the line varies only due to loss (it gets smaller).

You want a flat SWR?  Feed the load with a 1,000 ft spool of RG58.

The match at the TX end of the line ONLY affects the ability of the TX 
to deliver power to it -- the Z the TX sees must be something output 
stage is happy with, either due to the impedance ratio of the output 
network or protection of the output stage.

AND -- ANY length of line transforms the impedance. A quarter wave 
INVERTS the impedance (study a Smith chart to see what that means.) 
These slides for a talk I did several years ago illustrate that.  And 
the Smith chart software, SimSmith, is a GREAT tool. 
http://k9yc.com/PacificonSmithChart.pdf

73, Jim K9YC

  -- On Sun,6/11/2017 8:32 AM, Robert Morris wrote:
>
> While we are dancing with coax, and I don't have the original post, was the SWR always bad or did it just go bad.
>
> Looking at the Titan 425, it has a "lowpass filter" board, as in tuned input, with a bunch of those C and L things.
>
> Did the smoke fall out of the 10 meter section ?
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>